There could be nothing worse than coming home from a long day to a blocked toilet. Learning how to unclog a toilet without having to call a plumber (or 24 hour plumber if it’s the middle of the night) will save you both time and money. The best method to unclog a toilet will depend on how badly it has clogged. For minor problems such as those caused by too much toilet paper (often referred to as “soft” clogs) you may be able to simply wait the problem out. With most clogs, water will be trapped in the bowl and the simple force of gravity, combined with the loosening action of water, may be enough to dislodge the blockage. But you may have to wait an hour or so for the water to do its work.
To move things along a little faster consider adding a few generous squirts of dish soap (biodegradable if possible!) into the bowl of your toilet. If you let this sit for a while and flush with some hot water, it may dislodge and unclog your toilet. The properties of the dish soap act as a lubricant that can help the clog to detach from the sides of pipes. But remember not to flush if the water in the bowl is close to the rim. The bowl is designed to hold one entire tank of water, but typically not much more than this.
If you are in a hurry, or have a stubborn clog on your hands, then a good toilet plunger should do the trick. It is important that you create a solid seal over the entrance to the trap way in order to create the necessary suction and pressure to dislodge the toilet clog. Ensure there is some water in the pipes as water does not compress as much as air when placed under pressure. So if you plunge against water, you’ll be creating more pressure per push. If you are using a standard sink plunger you may find that this slips around on the curved surface of the toilet bowl (they are designed for flat surfaces). Far better to use a specialized toilet plunger that does it job perfectly. For more on how you can choose the best toilet plunger in UK later in this article.
How to unclog toilet with a plunger
If you feel tempted to unfold a wire coat hanger to try to reach what is stuck and break it up a little, bear in mind that the bends in the toilet trap way will usually keep the clog out of reach. Remember also that the wire of the hanger may scratch the porcelain of the toilet bowl, so be careful. unclog toilet. If none of the above approaches work and you’ve still got a blocked toilet, do not despair. You can always use a toilet snake or toilet augur.
A toilet snake may look unfamiliar but they are very easy to use. Simply place the end of the flexible cable into the toilet bowl and begin unwinding. The cable will extend round the bends in your trap way dislodging any clogs as it goes. If you come to the point where you feel some resistance, you will need to rewind the cable back into the bowl and remove anything that comes up with it. Repeat this process until your toilet runs clear. Toilet augurs can easily be bought online and are specifically designed to unclog a toilet. Click here for more information on purchasing a 3-Feet Home Toilet Auger by Cobra.
The first step in how to unclog a toilet with a plunger is to plunge the toilet with the rubber flange pulled out to get a better seal. Stick the plunger in the bowl and use it to form a solid seal over the exit hole. Push the plunger down until it touches the drain and then pull up sharply, but not enough to break the suction. I would hope that the bathroom in question would have hand soap, but if it doesn’t, one commenter suggests grabbing a bottle of shampoo from the shower, squirting some in the toilet and letting it sit for as long as possible. Push in and out vigorously, keeping enough water in the bowl to cover the plunger.
Rod said that most people only focus on the downward push when plunging. Repeat this a couple of times. If still nothing has happened you will probably need to use a different method (or bail some of the water out and add more hot water/ soap). Keep towels handy to wipe up water that splashes out. But the pullback is just as important. Hopefully, when you release the suction on the drain the clog should be dislodged releasing the water. So you have no plunger and you’re panicking. Give a few good up and down strokes with the plunger and flush the toilet. If there’s no change, repeat Steps 4 and 5 until the water begins to drain. You tried the hot water trick and IT’S NOT WORKING.
If the water clears from the toilet, then you’ve successfully unclogged it. Carefully pour the hot water into the toilet bowl to dissolve the liquid or bar soap. Your composure is quickly going down the tubes…pardon the pun. Add some hot water and let it sit for a while. The soap should quickly begin to unclog the toilet drain by helping the clogged object start sliding down the pipes. Don’t worry, there is another trick that does not require a plunger, just some dish soap. Things should start moving around and breaking up in a half hour or so, but in more extreme cases, you should be prepared to let the soap do its thing overnight.
As a last resort, you can use a drain cleaner but bear in mind that cleaners can be very harsh on the pipes and are typically not very good for the environment. There are enzymes that you can purchase that will literally eat the materials that are stuck in your pipes.